GSTARCAD | Knowledge Base

How to retrieve missing Command Bar?

From the Tools menu select Command Line. Alternatively, Command line can be enable or disable by using shortcut, CTRL + 9.

Attached Files
There are no attachments for this article.
Related Articles RSS Feed
4 SHIFT key combination you might not know
Viewed 1731 times since Sun, Apr 3, 2016
How to create Alignment Dynamic Block
Viewed 1146 times since Sun, Apr 3, 2016
How do I change Mtext to lower case or upper case?
Viewed 1108 times since Sun, Apr 3, 2016
How do I pack my files with eTransmit?
Viewed 1311 times since Sat, Apr 2, 2016
How do I purge layers that don’t want to be purged?
Viewed 1396 times since Sun, Apr 3, 2016
Why 3 reasons to like dynamic input?
Viewed 1173 times since Sat, Apr 2, 2016
How to add descriptions to blocks?
Viewed 984 times since Sat, Apr 2, 2016
With page setup win (save) money
Viewed 1178 times since Sun, Apr 3, 2016
How to Select a Group of Cells from an Inserted Table?
Viewed 1131 times since Thu, Oct 13, 2016
How to Fill up an Inserted Table?
Viewed 1161 times since Thu, Oct 13, 2016
MENU