GSTARCAD | Knowledge Base

How to create Chain Action Dynamic Block Creation?

If you want to realize symmetric stretch keeping keyway center no change and the length of smaller diameter shaft changes with stretch at same time, how will realize that?

1. Add Stretch for Step Shaft:

Add stretch parameter and action for step shaft as the following picture shows. Therein to the bolded objects indicates the operation object of action.

Because the follow-up operation will not stretch step shaft by grips of this linear parameter, the grip‟s number of linear parameter can be modified as “0”.

2. Add Linear Parameter for Keyways:

Set the base point position of line parameter as “Center” in order to realize symmetric stretch function.

3. Add Stretch Rightwards Action for Keyway

4. Realize Chain Action:

Select “Distance” linear parameter and modify the chain action of prosperity from “NO” to “Yes” as the following picture shows.
Add Stretch Leftwards action for keyway as the following picture shows. Special Notes: Do elect “Distance” to
linear parameter to stretch leftwards operation objects set. This is a necessary procedure of chain operation.

5. Test Dynamic Block:

After dragging left grip not only the keyway will stretch bi-directionally and symmetrically but also smaller
diameter shaft of step shaft will stretch automatically. This is chain action.

The realization of chain action has two important procedures: First, modify the property value of the
parameter that need to happen linkage and modify the property of “chain action” from “NO” to “YES”.
Second, select the parameter of objects that selected to linkage action to set.

Attached Files
There are no attachments for this article.
Related Articles RSS Feed
How can I arrange objects horizontal or vertically?
Viewed 1214 times since Sun, Apr 3, 2016
How to edit block attributes in Microsoft Excel?
Viewed 1720 times since Sun, Apr 3, 2016
How can I create a circular wipeout?
Viewed 3856 times since Sun, Apr 3, 2016
How do I purge layers that don’t want to be purged?
Viewed 1676 times since Sun, Apr 3, 2016
How to backup your Tool pallets in GstarCAD ?
Viewed 1325 times since Tue, Apr 12, 2016
How to convert a dwg file to pdf with added layer information?
Viewed 4028 times since Tue, Apr 12, 2016
Dynamic Block Editor - Actions
Viewed 1545 times since Sun, Apr 3, 2016
Move objects together or edit them individually by group tool
Viewed 2005 times since Sun, Apr 3, 2016
Where can I see the command alias list?
Viewed 2860 times since Sun, Apr 3, 2016
How to add descriptions to blocks?
Viewed 1430 times since Sat, Apr 2, 2016